- WATCHGUARD IPSEC VPN CLIENT TWO FACTOR AUTHENTICATION HOW TO
- WATCHGUARD IPSEC VPN CLIENT TWO FACTOR AUTHENTICATION SOFTWARE
!- In order to enable X-Auth for user authentication, !- enable the aaa authentication commands. !- Enable AAA for user authentication !- and group authorization. Configurations Configure the Cisco 2611 Router Cisco 2611 Router Note: The IP addresses in this example are not routable in the global Internet because they are private IP addresses in a lab network. In this section, you are presented with the information used to configure the features described in this document. Refer to the Cisco Technical Tips Conventions for more information on document conventions.
WATCHGUARD IPSEC VPN CLIENT TWO FACTOR AUTHENTICATION SOFTWARE
SuperLAT software (copyright 1990 by Meridian Technology Corp).ģ2K bytes of non-volatile configuration memory.ġ6384K bytes of processor board System flash (Read/Write)Ĭonfiguration register is 0x2102 Conventions System image file is "flash:"Ĭisco 2611 (MPC860) processor (revision 0x203) ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1) vpn2611# show versionĬisco Internetwork Operating System Software Output from the show version command on the router is shown in this output. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. No changes are required.Ĭisco VPN Client for Windows Version 4.x (any VPN Client 3.x and later works). Note: This document was recently tested with Cisco IOS Software Release 12.3(1). Routers that run Cisco IOS Software Release 12.2(8)T. The information in this document is based on these software and hardware versions. The no-xauth parameter is used on the ISAKMP key command for the LAN-to-LAN tunnel. Group and user authentication is done locally on the router for the VPN Clients. Prerequisites RequirementsĮnsure that you meet these requirements before you attempt this configuration:Ī pool of addresses to be assigned for IPsecĪ group called 3000clients with a preshared key of cisco123 for the VPN Clients Refer to Configuring an IPsec Router Dynamic LAN-to-LAN Peer and VPN Clients in order to learn more about the scenario where one end of the L2L tunnel is assigned an IP address dynamically by the other end.
Cisco IOS® Software Releases 12.2(8)T and later support connections from Cisco VPN Client 3.x and later.
WATCHGUARD IPSEC VPN CLIENT TWO FACTOR AUTHENTICATION HOW TO
This document demonstrates how to configure IPsec between two Cisco routers and the Cisco VPN Client 4.x.
0 kommentar(er)
